QUOTE

Quote Request Form


Please fill out the form below, and we’ll be happy to help you with your stamping press requirements. For immediate assistance, please call 931-393-5050.

Press Information

Options & Peripheral Equipment


Powered by ChronoForms - ChronoEngine.com

SERVICE

Service Inquiries Form


Please fill out this form for technical support or service. Someone will be in touch within 24 hours. If you don’t receive a response within 24 hours, feel free to call our office at 931-393-5050 as a technical issue might have caused us not to receive the form. After hours, call 931-581-7506.

Powered by ChronoForms - ChronoEngine.com

CONTACT

General Inquiries Form


If you need service assistance, click this link to contact our support staff. Otherwise, please fill out the form below and someone will be in touch within 24 hours.

If you don’t receive a response within 24 hours, feel free to call our office at 931-393-5050 as a technical issue might have caused us not to receive the form. After hours, call 931-703-9191.


Powered by ChronoForms - ChronoEngine.com

 


Mechanical Presses

Stamtec’s Mechanical Presses (a.k.a. OBG, OBS, OBI, or C-frame) undergo finite element analysis prior to manufacturing to ensure proper design, superior strength and maximum resistance to deflection

Mechanical, Forging, & Servo Presses for Your Complete Press-line Solution

Mechanical, Forging, & Servo Presses for Your Complete Press-line Solution

1-Point Straight Side Presses


Stamtec one-point straight side presses (a.k.a. single crank presses) feature precise slide guiding and frames designed to handle higher tonnage without the risk of angular deflection or yawning. Each press's fabricated steel frame undergoes rigorous finite element analysis prior to manufacturing and is of a heavy, box-type construction that is thermally stress relieved before being machined for uniform accuracy.

Select a straight side press below to learn more, and then contact us for the right mechanical press for your application.

Press Highlights

The massive bed of our one-point straight side press is built to a standard of no more than .0015-inch deflection per foot of bed length, both left to right and front to back, with a full-capacity load symmetrically distributed over two thirds of the bed area. This design provides superior compressive strength, deflection, torsion and vibration resistance.

The frame of these metal stamping presses is connected with four full-length steel tie rods that are hydraulically pre-stressed to 150 percent of press capacity and are welded together to form a single, unitized weldment.